Indestructible Spool Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple sturdy spool holder that fits every spool I have (I only buy 1KG spools).
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 56
- Wydruki
- 0
- Wyświetlenia
- 408
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
A simple sturdy spool holder that fits every spool I have (I only buy 1KG spools). I put in holes to fit M5 cap head screws for anyone who might want to use t-nuts to mount it on something but I just put it on top of my enclosure.
This spool holder uses 2x8mm 100mm steel rods and 4x8mm bearings. I used these ones.
https://www.amazon.com/dp/B076XVKMYK/ref=cm_sw_em_r_mt_dp_NH005DWTK086FEW1C4Q2?_encoding=UTF8&psc=1 https://www.amazon.com/dp/B07216D1SZ/ref=cm_sw_em_r_mt_dp_VGTK8WMG4DBYVEFZDMAZ?_encoding=UTF8&psc=1
Print one base and two rollers, push the steel rods through the rollers and put a bearing on each end. Drop the rollers into the slots in the base.
Print Settings
Printer:
Custom
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament:
Any PLAAny
Notes:
Make the walls 1.2-1.6mm for strength.
I printed the rollers standing up on end, be aware of the z-seam, if it's very pronounced it will be a place for the spool to stick against, either use random to break it up or expect to sand it off.Category: 3D Printer Accessories