Wire Spool Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wire spool hangers for my workbench overshelf
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 298
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
I made these brackets to mount an aluminum rod for convenient wire spool storage underneath the shelves on my workbench. Each rod can hold 4-6 wire spools, depending on gauge.
Hardware
2x Printed Part
1/2" x 12" Aluminum Rod
M2.5 Assortment Kit
- 4x 10mm M2.5 Socket Head Cap Screw
- 4x M2.5 Hex Nut
- 4x M2.5 Washer
Stainless Steel Overshelf
Assembly
Put the washers in the countersunk holes on the inside diameter, then the hex nuts. Push the aluminum rod through the hole. Install the bolts from the outside, as you tighten them, they will thread through the hex nuts and push against the aluminum rod. Add your wire spools then install a second printed mount on the other end of the rod.
With my shelf, there are 24.5mm between the inside faces of the two printed parts. Adjust this spacing to fit.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Filament: AmazonBasics PLA Gray
Notes:
PLA is strong enough as long as you don't overtighten the bolts.
Category: DIY