1 / 5
Fortnite Logo Lamp (with smaller on/off switch) and remote control with effects — zdjęcie 1
1 / 5

Fortnite Logo Lamp (with smaller on/off switch) and remote control with effects

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I modified the back cover slightly so that a 8A 250V/10A 250V switch will fit, which is slightly shorter.

Ocena
0 / 5
Polubienia
14
Pobrania
80
Wydruki
0
Wyświetlenia
758
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution

The switch used can be found here on Amazon NL:
https://www.amazon.nl/dp/B09F3F3BZG

Amazon DE:
https://www.amazon.de/-/en/Soldering-Eyelets-Rocker-Switch-Toggle/dp/B09F3F3BZG/

Amazon US:
https://www.amazon.com/ZUPAYIPA-Solder-Rocker-Switch-Toggle/dp/B01N2U8PK0/

Instructions from the original designer may be followed, however in my design I have soldered in an additional remote control board as I purchased my LED strip from Action NL (no online product link available) in order to get a cheap 24V power adapter to work with my LED strip.

Adding in the remote control board adds the ability to use the included remote control (From the original Action NL led strip) with the following functionality:
- Dimming: 25%, 50%, 75% or 100%
- Strobe effect aka blinking effect
- Fade effect aka breathing effect
- Timer to turn off the light after 15, 30 or 60 minutes
- On/off from the remote control in addition to the power button at the back

I have measured a peak power usage of 2.9 Watts at 100% brightness.

As this LED strip is rather powerful I decided to only add one rather than two as in the original design.

The LED strip I used is also from Amazon NL:
https://www.amazon.nl/dp/B09H494C56
Cutting off the size for this part results in a total of 18 leds (3 x 6).

I have printed this in all PETG:
- Prusament Galaxy Black for the back cover and case.
- Prusament Orange for the front of the Fortnite logo (last 5 layers), I've enabled ironing inside of PrusaSlicer
- Real Transparent for the base of the logo

Everything was printed with the Original Prusa MK3s, no supports were used.
I used a knife to cut away the strings at the switch and power jack cut outs.