12V Socket Vape Holder for Voopoo Drag X
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
No more leaking and rattling!
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 803
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was annoyed with my partner putting vape mod in cup holder and it constantly rattling around, leaking if left leaning for too long and worst of all: forcing me to hold any drinks when I'm a passenger because vape hogs one entire cup holder to itself.
Cue the solution: a vape holder that holds the mod upright snuggly and out of the way of other storage.
This should fit into standard 12V socket and while purpose–designed for Voopoo Drag X (PnP Kit) it should fit any mod with footprint fitting 30–35×25–30mm, anything smaller might not fit without falling out and bigger ones can be too tight to comfortably take in and out while driving.
Designed to be printed without supports in PETG (slow down bridges and overhangs to avoid messy finish), other materials like high shore (98A) TPU/TPE or anything that has some elasticity without cracking should work too.
New Version:
V2 now has slight change in plug design to fit in wider amount of V12 sockets with better tolerances and sitting in more snugly.