Gridfinity Dial Caliper holder for low-clearance drawer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design gets the calipers as low as I could without laying them on their side to fit in a drawer.
- Ocena
- 5 / 5
- Polubienia
- 49
- Pobrania
- 424
- Wydruki
- 2
- Wyświetlenia
- 2896
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a container for 150mm/6in dial calipers that gets them as low as possible without laying them on their side and taking up extra horizontal space. I had to leave out one of the magnet holes to make room, but the other 23 should hold it in place just fine. I have the Anytime Tools 6"/150mm Dual Reading Dial Caliper, so it fits that and similar models.
There was some extra space, so I added a groove for a couple pens or mechanical pencils and a hole to hold a pencil while it's on a desktop for quick grabbing.
I didn't go for a super tight tolerance around the calipers for a few reasons:
- I couldn't use my only set of calipers to measure themselves without damaging them.
- I wanted to be able to get them in and out of the box easily.
- Hopefully the looser fit will accommodate other similar models.
The footprint is 6x1 units, and it's 6 units tall, so I can stack short bins over the bottom of the caliper. It fits on an Ender 3 build plate at a 45º angle, just remember to adjust the fill angle to 0º if you have to rotate it.
I used Serpent10i's improved magnet hole design and designed it to be sliced with a .24mm layer height.