FLSUN v400 Speederpad Mount Remix v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Liked the original but didn't tilt enough. Tilted it back about 10 deg, made the dovetail a little easier(still tight)
- Ocena
- 4,5 / 5
- Polubienia
- 28
- Pobrania
- 401
- Wydruki
- 4
- Wyświetlenia
- 1676
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I like the original design but there was no tilt in the holder. Added about 10 deg tilt to the holder. Rounded the curves for the brackets that clip on to the V400 frame. Extended the portion of the bracket that has the dovetail receiver to account for the tilt added to the holder.
When printing it does need support under the dovetail portion of the holder only. Also included alternate clip STLs so it can be mounted to either side of the V400 frame.
(Update) per the good suggestions I received, updated V2 to have tighter tolerances for holding the speeder pad and made it so the pad can be slid out without unplugging it. I also lowered the back of the holder a bit so the cooling vent isn't blocked.