Display stand and sign for a bobcat skull
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This requires some handy work to assemble.
- Ocena
- 5 / 5
- Polubienia
- 41
- Pobrania
- 226
- Wydruki
- 1
- Wyświetlenia
- 1183
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Animals
- Licencja
- Creative Commons — Attribution — Noncommercial
This display stand was created as a christmas gift.
The skull's description was speaking about a bobcat from north America. Therefore, I took the liverty to label it "Lynx Canadensis". Original skull model: https://www.thingiverse.com/thing:1644120
In order to hold the skull, a 10mm hole must be drilled in it. Optionnal hardware for this project are :
2x (6x3mm) cylinder magnets to secure the upper part of the skull on the stand.
4x (3x3mm) cylinder magnets to keep the jaw attached to the upper part.
My printing advices :
Print the label sign at 30% infill with a small support. (15min)
Print the display stand at 80% infill with no support. (2 to 3 hours)
Print the skull at 30% infill with tree supports. (14 to 16 hours)
Time estimates are from prints with a 0.2mm layer height.
Finally, as I was designing the stand, I noticed some errors within the skull's mesh. I have posted a fixed version of the upper part along with the other files. Please note that I have used the orignial file to print my own skull and did not run into any printing issues.