SMD unsoldered holder for measurement.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an attempt to help the unsoldered SMD components measurements/test.
- Ocena
- 4 / 5
- Polubienia
- 20
- Pobrania
- 81
- Wydruki
- 1
- Wyświetlenia
- 860
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
This is an attempt to help the unsoldered SMD components measurements/test. Some components have the markings but some of them not, especially the capacitors.
After print you need to solder the wires to the metal plates and glue them to the model. See the images. Then insert the plunger to the body (at the beginning it goes tied but then it locks and should be moving free).
Connect the model to the measurement device. Any component tester can be used for the measurements.
To measure, put the SMD component to the pocket and press/hold a plunger during measurement.