Spice Rack (Modular / Scalable / No Supports)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact modular spice rack. Print as much or as little slots as you need.
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 493
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Overview:
Compact and cute spice rack. It's modular so you can print exactly as much as you need.
Instructions:
Where to get the tubes:
The ones in the photo are 25x100mm. I couldn't find same dimensions online (I bought mine in a local craft store) so if you can't get those I added models for 25x110mm which you can order here (or wherever else, that's just a random shop on Ali Express).
*If the link no longer works when you find this model, search for “Plastic test tube 25x100” (or 25x110)
Print and Assembly:
If you have 10cm tubes use models that end with 10 for 11cm tubes use those which end with 11. Models without a number work for both.
* 11 cm will work for both, I just personally like when it's more compact =).
All models can be printed without supports!
If you only want one row, than you need to print Bottom_Holders * as much as you need, Bottom_Double_Connectors one less than the amount of holders and also print labels.
- Put two holders side by side and slide the connector over both slots on the bottom of each holder.
- Repeat ;).
- Put labels in place and you are done.
If you wand to add the second row you need to print Left_Stand, Right_Stand, Upper_Holders * as much as you need, Upper_Connectors one less than the amount of holders and also labels. Additionally for each Stand if it's going to be on the side of the bottom row print Bottom_Double_Connector and if it's in the middle print Bottom_Triple_Connector instead.
- Connect stands to the bottom row the same way as you connected bottom holders together (with Bottom_Double_Connector or Bottom_Triple_Connector).
- Slide first Upper_Holder into the Right_Stand until it reaches the notch.
- Slide Upper_Connector onto the other side of Upper_Holder until it reaches the notch.
- Slide next Upper_Holder onto the other side of the connector.
- Repeat until you reach the Left_Stand.
- Bend Left_Stand slightly to insert the last Upper_Holder.
- Put labels in place and you are done.
*If the second level is too long and starts sagging, replace connector in the middle with Middle_Stand.
*If the tolerances are too tight, you might want to use a little persuasion (e.g. hammer) =)
*Comment if you want me to add some more labels.