1 / 3
Threaded pass through for 1.625" hole — zdjęcie 1
1 / 3

Threaded pass through for 1.625" hole

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A smaller version of TimATX's Threaded 6" pass through.

Ocena
0 / 5
Polubienia
31
Pobrania
127
Wydruki
0
Wyświetlenia
3452
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

First - thank you TimATX for creating the original model.
Threaded 6" pass through by TimATX | Download free STL model | Printables.com

I needed a smaller version to create a sealable air hole/port in the top of my Sovol SH01 filament dryer.  I scaled it and cut the height of both pieces to make it fit correctly.  This is a bit more challenging than simple scaling as I had to adjust the cap after scaling to make the threads work properly.  I then reduced the height of the assembly to prevent them from hitting the top of the spools sitting inside the SH01.   I crudely did the modifications in Bambu Slicer as I am unfamiliar with 3d CAD software.   

Notes:

  • The inside diameter is about 1.2 inches.
  • This will fit perfectly into a 1.625" size hole.  
  • The “back-up” ring was omitted from original design.
  • Printed on Bambu Labs X1C using Overture PLA
    • .16mm layer
    • 15% infill
  • The cap proved difficult to print and is somewhat rough.  I printed it cap down (threads up) with tree/hybrid supports.  YMMV.