Makerfarm Prusa i3v radial part fan mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Part cooling fan mount for a Prusa MK3 type fan to go on a Makerfarm i3v. Needs supports.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 163
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Mount for a radial fan (XYJ05S5015H) for part cooling on a Makerfarm i3v (10").
It is mounted on the two hotend screws, on top of the hotend fan.
This fan provides a lot of air, so a silicone sock on the original E3D v6 hotend lets you run the fan over 20% without cooling down the hotend too much. The sock lets the fan run full speed on temps around 200. The sock will also protect the duct at higher extrusion temps.
The other issue is that the part needs supports; slic3r autogenerated supports are not friendly to the old Makerfarm with lower resolution Z axis, which cannot handle tiny layer heights. I used a Prusa Mk3 to print this in PETG.
The new prusa organic supports (or mesh mixer supports) work on the maker farm.
Finally, set any fan speed increases to occur over a few layers, otherwise the fan dumps on the hot end and drops the temp faster than it can catch it, causing extrusion problems.
9/17/25 - I raised the bottom 2mm to close down the air flow and point it down more. It was putting too much air on the hot end [DUCT3 model] for my fan. Now it has better clearance and I can run my fan over 20%.