1 / 4
Old Werner Ladder Cap
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
I needed replacement caps for my old ladder and the best I could find was larger one with two holes. I needed the smaller set. I remixed with Tinkercad to make the smaller cap with one hole to match my ladder.
Assembly: The original caps were aluminum riveted. I drilled them out with a ¼" drill bit. I bolted the new ones on with ¼-20 stainless steel screws, washers, and nuts.
I made these about two years ago with PETG for the durability. Not sure of infill, probably 50%, 0.2 layer.