Analogue Pocket Stands
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two versions of stands for the Analogue Pocket.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 26
- Wydruki
- 2
- Wyświetlenia
- 562
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial
Two versions of stands for the Analogue Pocket.
They can be used just to hold the device, to charge it or to charge it and have an audio connection. No HDMI like the original!
The charge/audio version (Stand 2) is highly experimental! The alignment of the two connectors is very critical since the Pocket is missing some ‘slide-in bevels’ for the USB-C connector. I started by sliding in the pocket into the stand, then added the 3.5 mm audio jack to it and then the USB-C 90 degree adapter. Then I have used hot glue to keep everything in place. Add a small amount of hot glue to the USB-C adapter, slide in the little rectangle piece and then glue everything tight and steady.
Due to the audio output, the second stand can't be tilted, so just version 1 can be either tilted by using base1 or straight by using base2.
I'm using the 90 degree USB-C cable by Ugreen for stand1
print instructions:
I have used PETG (Prusament) and a 0.4 mm nozzle at 0.2 mm layer height.
no support required, 2 perimeters and 25-75% infill, depending on how ‘heavy’ you want to get the parts.