Sabre 3D Printed Wing Parts

Sabre 3D printed plane parts

Original plane design can be found here

Oliver C Youtube video here

All these designs are tinkercad specials. Nothing super fancy, but quite functional. Big Shout out to oliver c for his original design.

Sabre_nose_dji_O3.stl:

• Nose that fits the DJI O3 Air Unit Camera
• Large scoop up top, and 2 on the sides of the camera to cool the vtx

Sabre_nose_dji_OG.stl:

• Nose that fits the original DJI Air Unit/Vista camera
• Large scoop up top, and 2 on the sides of the camera to cool the vtx

vista mount sabre.stl:

• Front sled for the sabre with 20x20 mounting. I printed in petg and sunk m2 brass fittings into the holes with a hot soldering iron around 230C. then just screw the vista in from the top. using some gummies underneath is recommended so airflow can get under the vista.
• Glue in with ca glue to the front rails

FC mount matek sabre.stl:

• Rear sled for the sabre with mounting for a matek f405-wmn, and also the daughter breakout board for the buzzer and usb, to be mounted on an angle so usb access is easy. Also has mounting for a matek m8q-5883. I put vhb under each item and stuck them on. The main flight controller also got m2 screws. Glue this to the rear
• Glue in with ca glue to the rear rails. Escs can mount under the sled for a clean look, but BE CAREFUL of the screw heads if you have the fc screwed in.

sabre mount.stl:

• Wall mount for the sabre. Stick to wall with 3m command strips.

Category: R/C Vehicles