Articulated lizard with holes for magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of the famous lizard to fit four 3x2mm magnets in its feets.
- Ocena
- 4,5 / 5
- Polubienia
- 111
- Pobrania
- 612
- Wydruki
- 5
- Wyświetlenia
- 3642
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Building Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I cut some holes for neodymium magnets with 3 mm diameter and 2 mm thickness. There is only one layer between the build bed and the magnets. It was a tight fit for me, so it may depend on the calibration of your printer if it works for you. Check your slicer to see at which layer you need to pause the print, but as late as possible. Push the magnets as deep as you can into the holes so the nozzle doesn't bump into them when you print the next layer. While you're at it, you can also change the filament. I think changing from white to green worked well for me.
Thanks for the great model, McGybeer!