Gaggia Classic steam valve seat polisher
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A tool for polishing the valve seat instead of using a 5mm end mill for Gaggia Classic steam valve refurbishment.
- Ocena
- 5 / 5
- Polubienia
- 9
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 864
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Public Domain
See Brew Better's video for refurbishing Gaggia Classic steam valves:
[Edit: this did work for me for a time but the problem returned. I think there was pitting in the valve seat. In the end I wrapped some tape around a drill bit until it fitted snugly down the hole and gently polished the seat by hand. That worked a treat. I'm leaving the model here because it may work for you but if it doesn't the drill bit method may be better.]
This tool can be used with a hand drill to polish the valve seat. The 8mm part of the shaft fits snugly into the end of the valve and aligns the 5mm end for polishing the valve seat.
Print the tool out with the 5mm end downwards. Stick a small disk of sandpaper to the end of the tool.
I used:
- PLA.
- 3mm brim.
- 0.1mm layer height.
- 3 perimeters.
- 25% gyroid infill.
- Slow print speed.
And I had to sand the 8mm part of the shaft smooth to get it to fit into the end of the valve - it is a very snug fit.
This is really only for a one-off. If refurbishing multiple valves then a better plan would be a 5mm end mill with a printed collar with 8mm OD and 5mm ID.