Lucky 13 remix: R2-D2

UPDATE 2/10/2024: Be sure to check out the R2-D2 feet remix for use with the DUMMY 13 - Acrobatics pedestal

I recently made a Lucky C-3PO by Printables user egz and decided there needed to be an R2-D2 to go along with it. If you like this, check out my Lucky 13 skin: General Grievous

Assembly won't be difficult at all. If there is a [2X] next to the title of a piece, that means you need two of that piece.

You will need supports for Head Skin - Grey.stl

CHEST

Pieces that you will need:

1. Chest Skin - white.stl

2. Chest Armature - white.stl

3. Middle Foot - white.stl

4. Chest part 1 - Blue.stl

5. Chest part 2 - Blue.stl   [X2]

Chest Armature - white.stl fits into Chest Skin - white.stl and then connects to Middle Foot - white.stl while Chest part 1 - Blue.stl and Chest part 2 - Blue.stl   [X2] fit into the Chest Skin as seen in the picture below.

HEAD

Pieces you will need:

1. Head Armature - Blue.stl

2. Head Skin - Grey.stl

3. Head part - black.stl

Super easy assembly for the head. Head Skin - Grey.stl fits over top of Head Armature - Blue.stl and then Head part - black.stl fits into the head armature.

LEG

Pieces you will need:

1. Leg Skin - white.stl

2. Outside Foot - white.stl

3. Leg Armature - Blue.stl

Again, super easy assembly. Leg Armature - Blue.stl fits into Leg Skin - white.stl and then snaps into Outside Foot - white.stl. Repeat the process for the other leg and the connect the Legs, Head and Chest.