1 / 6
14cm wide x 14cm long x 23cm high Wavy Tensegrity Table — zdjęcie 1
1 / 6

14cm wide x 14cm long x 23cm high Wavy Tensegrity Table

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A tensegrity table with freeform waves which can be used as a display piece to hold small objects on top of.

Ocena
0 / 5
Polubienia
2
Pobrania
18
Wydruki
0
Wyświetlenia
466
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Noncommercial

Lesson Plan and Activity:


 

With a partner, design and create a single custom Tensegrity Structure of equal complexity or greater as the tables depicted above.

Parts List:

2 connector pieces, 1 bottom base piece, 1 top base piece

10 small screw hooks

About 192 cm of fishing line(recommended to use slightly more to account for excess)


Assembly/Construction Instructions Section:

Check to see if all marked screw holes printed properly

  1. If needed(ie; screw holes are too small), align Phillip’s head screwdriver or awl with screw holes(1 on each connector, 4 on each base)

     
  2. Lightly hammer on the end of the screwdriver or awl to widen the hole and allow the screw hooks to “bite” in(hold the piece down with a vice or have someone else hold it down)
  3. Grap screw hook using pliers, align it with a screw hole and turn it in, applying pressure, until screw is fully in and not moving
  4. Repeat previous steps for all screw holes
  5. Pick ONE connector and cut off the end of the hook that is attached to it
  6. Attach the connectors together using the hooks
  7. Slot connectors into corresponding slots on bases
  8. Cut string or fishing line into 4 equal pieces
  9.  Connect corresponding hooks on bases using string or fishing line and tighten
  10. Tie the excess string in another knot after finishing tightening all the strings
  11. Cut off excess string and adjust the string so the knot is on one of the hooks


 

Design Choices:

  • Original plan was to use the spline tool for the sides and surfaces of the top and bottom pieces
  • Also meant to use random extruded shapes with spline tool, fillets, and drafts to make flowing shapes
  • Spline tool ended up looking too uniform
  • Decided to switch to using freeform tool for faces of the base and shapes
  • Assembled parts together
  • Also added more shapes so that there was one in each corner, which looked more consistent and gave good anchor points for hooks later
  • We decided that the connecters were also too uniform, so we made new connectors which curved more
  • Also made two different connectors instead of having two of the same one
  • Assembled new connectors with other parts
  • Added pegs to be able to precisely place screw hooks after printing
  • Added model screw hooks and model strings into assembly to determine if there was anything blocking them
  • All parts ended up to be very small, so added a 2x scale to the top and bottom pieces in the x and z axes to keep them at the same thickness
  • Added a 2x scale in all directions for the connectors as they had the same issue
  • Screwing hooks into the version 1 connectors proved very difficult, decided to create a flat section with a guide hole to make it easier to screw in the hook
  • Also decided to print two copies of one connector instead of having two different ones, as it was confusing which one would go with which base
  • Extended the pegs on the connectors and the peg holes on the bases to be proportionately twice as long and deep respectively