1 / 3
Pegboard screwdriver holder for 4mm holes and 12mm spacing (Biltema)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed the screwdriver holder for my pegboard (4mm holes with 12mm spacing).
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 131
- Wydruki
- 0
- Wyświetlenia
- 623
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (27)Powiązane
Remixed the screwdriver holder for my pegboard (4mm holes with 12mm spacing).
Made to be printed upside down without supports. May need some skirt to support the small hooks that are built from the table.
The hooks are quite thin, but the strength is surprisingly good.