bsa meteor mk5 mainspring compression tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
bsa meteor mk5 mainspring tool to use with a sash clamp
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 74
- Wydruki
- 0
- Wyświetlenia
- 389
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Bsa meteor mk5 mainspring compression tool I use it with a Silverline 613111 sash clamp
Must be printed at 100% infill in the upright position.
0.20mm layer height
I use pla for it without any problems
Please note that you can be seriously injured if you don't know what you are doing by removing or installing a mainspring. I I have used this tool for quite a while now with no problems but don't accept any responsibility for any damage or injury caused buy using it.
**It has been brought to my attention that my design has been stolen and is being sold on a auction site. I don't mind people printing and selling my designs but it would have been nice if I were asked if it was ok. The model was ordinally posted with no commercial use but it looks like that means nothing**