1 / 5
1/10 RC car Tire + wheel, 275/60 R20, Michelin XZL tread profile for OFF-ROAD VEHICLES — zdjęcie 1
1 / 5

1/10 RC car Tire + wheel, 275/60 R20, Michelin XZL tread profile for OFF-ROAD VEHICLES

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a smaller scale tire. It has a specific mount I will be using in my new RC car design (see details).

Ocena
0 / 5
Polubienia
44
Pobrania
270
Wydruki
2
Wyświetlenia
1467
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Vehicles
Licencja
Creative Commons — Attribution — Noncommercial

This is the size I'll be using with my Dodge Ram remixed body ( I'm going to re-remix this body but that's  another story !)

The tire prints without supports and without infill when put on the side. With TPU (depending on the brand) it should take ca 4.5 hours per tire (0.3 Draft) .  My print was with Overture TPU and I used the Amazon basics TPU print profile on Prusaslicer 0.3 Draft no infill; it took about 6 hours.

With other TPU profiles you can get shorter times but I wanted to be on the safe side. I also tried PLA (last photo). It's much faster and the result is nice and the color is mate so more realistic. But obviously it is hard and not suitable to drive on concrete.

The rim comes in two parts that are assembled with 3 M3 screws screwed directly into the plastic. ca 1 hour per wheel (PLA 0.3 draft)

Dimensions: 

tire = 84 mm x 27.5 mm (1/10 scale for a 275/60 R20 tire)

Rim = 50.8 mm x 25.5 mm

The mount is a 6.8 mm diameter shaft cut at 5.8 mm (symetric)  and a M3 screw hole.

You can get a glimpse of front wheel assembly as per the curent progress of the design. This time the motor will sit on top of the differential.

 

Tagi