Pimorony Inky Frame 4.0" + Accessory Kit case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A snapfit Pimorony Inky Frame 4.0" with the AAA battery holder from the accessory kit
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 80
- Wydruki
- 0
- Wyświetlenia
- 746
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
A snapfit case for the Pimoroni Inky Frame 4.0" with the Accessory Kit AAA battery holder: https://shop.pimoroni.com/products/inky-frame-4?variant=40443825127507
The batteryholder inserts with the on-off switch to the back, so I printed this in PETG (you have to wiggle it in place)
Tolerances work for me with a Prusa Mk3s, printed at 0.2mm with Prusament Galaxy Black
Buttons printed at 0.1mm without supports as the bridging worked fine, if your printer prints easily removable supports you could do so, just be careful while removing them.
There are screwholes for wallmounting, let me know if it fits the “common” wall screw size (I assumed 6mm dia for the large and 4mm dia for the small hole)
For software check out Kevin J Walters great Instructable: https://www.instructables.com/Battery-Powered-Digital-Picture-Frame-Using-Pimoro/
For more info about the software: https://forums.pimoroni.com/t/inky-frame-slide-show/19996
For an Inky Frame 5.7 case check out: https://www.printables.com/model/314493-inky-frame-case