ArduCam Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Shroud / casing / stand for the Rev.C OV5647 Camera for Raspberry Pi. Same sensor as in the original (v 1.3) Raspberry Pi camera, but with a proper lens.
More about this camera can be found here:
http://www.arducam.com/raspberry-pi-camera-rev-c-improves-optical-performance/
I bought mine here:
http://www.ebay.com/itm/281212355128?\_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Print instructions
Category: Camera Summary
Shroud / casing / stand for the Rev.C OV5647 Camera for Raspberry Pi. Same sensor as in the original (v 1.3) Raspberry Pi camera, but with a proper lens.
More about this camera can be found here:
http://www.arducam.com/raspberry-pi-camera-rev-c-improves-optical-performance/
I bought mine here:
http://www.ebay.com/itm/281212355128?\_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
Print Settings
Printer: SUMPOD
Rafts: No
Supports: No
Infill: 50%
Notes:
Printed at .1mm layer height.
Post-Printing
Tapping
Apart from cleanup the only thing you need to do after printing is to tap the 4 screw holes in the casing with an M3 tap.