2008 Toyota Sequoia Wireless Charging Tray for Console
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fits 2 Anker 315 wireless chargers and has a bottom cord channel. Printed with PETG 10% infill and supports.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 658
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Public Domain
Just a basic tray for that I made in Tinkercad for my 2008 Toyota Sequoia. This fits the center console and holds 2 Anker 315 chargers, one side is larger than the other as my phone & case is a bit smaller than my wife's - you should be able to easily adjust as needed. Cable channel on the bottom to keep the cord from dangling in the console, and the front side has a notch out of it to allow space for the USB ports to stick up from the DC port (I had to replace my DC outlet with a USB outlet)--there was a slight gap produced when I removed the supports that you can see in the picture, but I don't even notice it when it's in place. I printed with PETG, 10% infill and supports. The pins will probably need to be on a raft and need slight trimming to fit the hols, no glue is required.