Bike cassette sprocket cleaner, scraper (8-9-10 speed cassettes)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This scraper works with 8, 9 and 10 Speed Cassettes. Maybe also with 11 speed, but I haven't tested that yet. Since…
- Ocena
- 5 / 5
- Polubienia
- 45
- Pobrania
- 145
- Wydruki
- 3
- Wyświetlenia
- 940
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
This scraper works with 8, 9 and 10 Speed Cassettes. Maybe also with 11 speed, but I haven't tested that yet. Since the gap between the sprockets is a bit different on different speed cassets, there are 2 files for the middle part of the scraper. One is a bit thicker to fit better on 8 speed cassettes, but you can also use the thinner one on 8 speed cassettes.
Make sure your printbed is leveled correctly and the printbed adhesion is good because otherwise these parts may warp easily. I printed the scraper with PLA and it works fine.
Additional parts needed:
2 countersunk bolts M4 x 12 mm
2 nuts M4
Category: Hobby