Ender 6 Waveshare 4.3" Adaptor Plate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This allows you to continue to use the metal housing for the ender 6 screen with KlipperScreen.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 465
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- GNU General Public License v2.0
Please print this in the orientation shown on the images.
This allows you to continue the use of the metal housing. I took a longer DSI cable and mounted my PI4 under with all the electronics. you can find many brackets to-do this.
What you need:
Included hardware with printer
Mounting screws for screen(these should also come included)
Longer cable to feed through to raspberry pi.
How to:
Access your screen housing by removing all four screws located at the back and under side of the metal housing (keep these to one side)
Remove 4 screws holding the original screen in place. (save these for later)
be sure to leave the rubber gasket in place. Removing any wiring from the mainboard freeing the screen you can then place this to one side.
Slide waveshare 4.3" into the bracket and secure with 4 screws. (these should be the 4 included mounting screws.
Slide bracket over the 4 posts inside orignal metal housing we can then attach these with the four screws that held the original screen in place.
Attach your cables to your PI however you see fit and secure housing using the original hardware that we set aside earlier.