Traxxas Slash 2WD Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
All of the stands I have found are for the Traxxas Slash 4x4, so I took it upon myself to design a simple stand for my…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 124
- Wydruki
- 0
- Wyświetlenia
- 717
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
All of the stands I have found are for the Traxxas Slash 4x4, so I took it upon myself to design a simple stand for my Slash to keep the wheels off the ground when in storage on the shelf.
For assembly, you need the following:
(8) M3x10-12mm screws. The "pre-drilled" holes are 12mm deep, so do not use anything longer than 12mm!
This is a new model that has not yet been fully tested, so if you have any modifications you find beneficial to the design, feel free to reach out.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
.2mm
Infill:
20
Filament: eSun PLA Plus Any
Notes:
The sides and braces do not needs supports however, I recommend you stand the top up on its end and print with supports.
Category: R/C Vehicles