SLAB Skeleton Stock

Skeleton stock for Sillybutts' SLAB. Uses the stock screws normally used for the slab, in addition to two ¼" nuts and bolts (between 25mm and 28mm long, or roughly between 1" and 1-¼" long). You may also try using washers to prevent the plastic of the stock becoming chewed up, but other than those two ¼" nuts and bolts, no additional hardware is required. Tolerances of the interlocking parts should be able to accommodate any 3d printer, but your mileage may vary. This design replaces the entire stock assembly of the slab, and is not compatible with any of the basic stock parts.

To assemble, you will need the Skeleton stock, one of the butt plates, the butt pad, the cheek rest mount, the cheek rest lid, and one of the two cheek pads. There are two files for the cheek pad, one of which will print laying flat on the bed, the other in an orientation such that layer lines will not dig into your cheek. All prints should print support free. If I think of anything else I will update here. The dart holder you see in one of the pictures is a work in progress and will be released soon. Step files are also included, should you want to edit this stock in any way.