Open CNC Shield 2 Housing for LowRider 3
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This housing for the Open CNC Shield 2 was made for the Lowrider 3 (or any other CNC).
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 416
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- GNU General Public License v3.0
This box was made for the Open CNC Shield by Timo Altholtmann and the Lowrider 3 (or any other CNC), it works well together with the drag chain holders I and design8studio designed. It could be used for any other CNC as well, just the keyhole hangers are especially made for the LR3. The housing uses CNC-cut parts, because my 3D printer is not big enough for the printed parts of other versions for this board. It has slots for the cables, holes for zip-ties to hold the cables and one hole for a button that starts the autosquaring provided by the ESP32.
The brackets are 3D-printed and need four 5x4mm magnets (though they should hold without them as well, but no promises).
The sides are made out of 4mm acrylic, cut with a 3mm 1-flute, trochoidal milling, 4.2mm DOC and 1500mm/min speed, lowish RPM. The corners are only cut 2mm deep, they are being glued in the brackets (the holes have been fixed and should match now, so the corners can be secured by 3mm screws as well). The 3mm holes in the board were made with a drill bit with low RPM and a Z-travel speed of 150mm/min. Everything was done without cooling.