Voron 0 MGN7 Alignment clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My better alignment clip with slightly different shrinkage tolerance and holes instead of right corners
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 182
- Wydruki
- 2
- Wyświetlenia
- 549
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I tried to use default voron clip (via PIF) for alignment of the rails but it was not good enough on tolerances, reprinted it myself however found that 7mm rail cutout possibly had wrong shrinkage compensation. It gave me non-parallel rails. Tried another tool from printables however it wasn't stiff enough to put rail in place so I designed my own variation with tighter tolerances so both 15mm profile and 7mm rail fit snugly into this tool. Has holes where 90 degree angles would contact rails and profiles as attempt to make it fit better.