1 / 4
Creality Ender 3 H2 V2S REVO 12mm Microprobe holder — zdjęcie 1
1 / 4

Creality Ender 3 H2 V2S REVO 12mm Microprobe holder

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Remix of JJR3D's Microprobe holder for the ender 3

Ocena
0 / 5
Polubienia
4
Pobrania
14
Wydruki
0
Wyświetlenia
715
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

I liked JJR3D's probe holder for the H2 V2S revo as it was the closest one to the nozzle out of all the others I had seen but it was for a microprobe so I had to adapt it for my ender 3 sensor.
This fits a 12mm probe and when fitted it is about 20 mm out from the y axis and inline with the x axis.
when assembling on the h2 v2s pop the screw in the bottom hole and do it up with a small gap then slide the holder down over the top. pop 2nd screw in at the top and its a nice solid fit.
 

BTT skr mini e3 v3 board, BTT tft35 v3.01, top mounted linear rail, ABL sensor, solid bed mounts, Biqu H2 V2S Revo hotend/direct drive.

settings: Translucent Orange petg, temps 240 nozzle - 70 bed print speed 55mm no supports.

Tagi