Nano Skyhunter - APM Mini GPS Mounting Tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a remix of Zapf's mounting tray for the Nano Skyhunter. It has been lengthened by 2mm and new mounting holes…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 135
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of Zapf's mounting tray for the Nano Skyhunter. It has been lengthened by 2mm and new mounting holes (32.5mm x 32.5mm center to center) have been created to allow mounting a APM mini GPS that uses the same mounting hole pattern.
I printed mine with 4 bottom and 4 top solid layers, 0.100 layer height, 10% infill and 2 perimeters.
Instructions:
Attach standoffs to the holes in the mount
Attached your flight controller or GPS to the standoffs
Slide out the existing wood tray from the Nano Skyhunter
Place the mount in at a slight angle press into the slots in the foam
Slide tray backwards into final position
Print Settings
Printer:
Raise3D N2
Rafts:
No
Supports:
No
Resolution:
.100-.200
Infill:
10-20%
Category: R/C Vehicles