1 / 3
Lee Universal Case Feed Tube Spacer — zdjęcie 1
1 / 3

Lee Universal Case Feed Tube Spacer

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Wstępna wycena dla PETG

0,28 € – 0,34 € netto (bez VAT)

Dla pliku: LeeUCFTubeGuideRing_x2_0.6n_0.3mm_PETG_MK3SMMU2S_16m.gcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 0,31 € netto (środek widełek).

Masa podana przez autora
5 g
Czas druku podany przez autora
16,2 min
Materiał u źródła
PET
Materiał wyceny
PETG
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

A spacer ring for the feed tubes on the Lee Universal Case Feed system.

Ocena
5 / 5
Polubienia
12
Pobrania
147
Wydruki
1
Wyświetlenia
679
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A spacer/guide ring for the feed tubes on the Lee Precision Universal Case Feed system. Provides some support for the tubes and prevents them from flopping around when you pull the tubes out of the base, which also makes reinserting the tubes in the base easier.

The spacer ring has been designed with very tight clearances, which is necessary for it to function as intended. When installing the spacers, I recommend first running a single tube through each of the four holes on the spacer to make sure it fits; it will be snug. Make sure to clean up any stringing or crud inside the tube holes of the spacer before attempting to install. I recommend printing and using two spacer rings, spaced equally on the tubes as shown in the photo.

 

Print Recommendations:

  • 0.4-0.6mm nozzle
  • 0.2-0.3mm layer height
  • 2 perimeters
  • 100% infill
  • PETG or PLA

 

Change Log:
  • 08APR2023 – Updated model and print files — added a bit more ID clearance to make installation a little easier; added print file for PLA.

Tagi