1 / 6
Kid's project: Origami mobile with bamboo skewers — zdjęcie 1
1 / 6

Kid's project: Origami mobile with bamboo skewers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Fun kid's project and educational lesson about balance, resulting in a mobile that's relaxing to look at.

Ocena
0 / 5
Polubienia
11
Pobrania
27
Wydruki
0
Wyświetlenia
655
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a fun project to do with kids. Make some small origami decorations, or anything else small that could be hung on a mobile, and use 3D printed clasps on bamboo skewers to attach the objects, sliding the claps as needed for balance. The mobile pictured here hangs above my son's bed, and he enjoys watching it (and blowing on it) while lying in bed.

The 3D printed skewer clasps are designed for the long (10-inch) skewers, which are 3mm in diameter. The short ones are thinner. Use the long ones; you can always cut them down.

The clasps give stability to the balance of the mobile. The problem with bamboo skewers is that they are straight, and simply tying threads onto them results in a mobile that is unstable and difficult to balance. Ease of balancing arises when the tie-points on the ends of the skewer are lower than the tie point in between, forming a dihedral angle between the three tie points. Instead of this arrangement:

We have this, where the clasps on the skewer rod offset the tie points from the rod:

The dihedral angle between the tie points increases the stability of balance. The clasps can be slid along the rod for fine-tuning the balance.

When constructing a mobile, it is best to create all your hanging objects first. They can be small paper airplanes or other origami objects, small jewel pendants, cardboard cutouts, 3D printed space ships, or anything that has a hole in it to suspend by a thread.

After creating the objects and printing the clasps, plan out your mobile, and start building it.

  1. Slide three clasps onto each skewer rod from the pointy end.
  2. Clip off the pointy end, and if necessary, cut your skewer rods to size.
  3. The hardest part is tying the threads to the clasp holes.

Start constructing the mobile from the bottom, because every tie point above must balance the weight of everything below.

Print Settings

Printer: Prusa I3 MK3S

Supports: No

Resolution: 0.20-0.30mm layers, 0.4mm nozzle

Infill: none

Filament: Any (I used Prusament transparent PETG)

Notes:

Be sure your slicer doesn't create a bridge across the expansion gaps of the clasps.

Hardly any surface area is in contact with the build plate, so use an external brim. 2mm is sufficient. The model is designed with a small bridge across the expansion gap that doesn't print; the purpose is to prevent the slicer from putting a brim inside the hole.

Print with a neutral color. The model provides 5 sets of clasps (3 per rod), which accommodate 5 rods, which in turn can suspend 6 to 7 objects depending on the arrangement.

Post-Printing

Stray threads from the printer nozzle may bridge across the expansion gap in the clasps. Use your fingernail, knife, or a needle to break these bridges, otherwise the clasps cannot expand, making it difficult to slide them onto the rods.

 

Category: Interactive Art

Tagi