CBR600F4i Front brakeline guide for dual lines
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Replaces original splitter with a mount for a single brake line
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 283
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
The original rubber brake line setup has a hose line splitter mounted on the right mudguard, new braided steel brake lines often come as a “race” setup, two separate lines meaning the splitter isn't required nor useable as a mount.
This replaces the splitter with brake line mount of similar dimensions, it holds onto the HEL Performance brake line rubber boot/grommet/thingy.
Obviously anything that goes wrong on a motorbike has the potential to be very nasty, my brake line is fine without this mount it just tidies it up, make sure your brake line is unable to touch the wheel without this mount first! Use your own judgement if this is safe enough for you.
Printing Instructions
This is a rushed model so it requires supports to support the underside of the square portion (mudguard side), print orientation should have the grommet holder printing vertical