1 / 7
Glowing Mushroom with LED's and CR2025 Batteries — zdjęcie 1
1 / 7

Glowing Mushroom with LED's and CR2025 Batteries

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A cool little project for Kids. This Mushroom is easy to assemble, requires nearly nothing extra and looks stunning.

Ocena
0 / 5
Polubienia
10
Pobrania
48
Wydruki
0
Wyświetlenia
339
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Engineering
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Made this one originally as a gift for the Premiere of the Play Antropos Antigone, but then I thought Kids might like it too. 

To save time, I first printed it at a third of the original size, to get 20 little Mushrooms over night. The full single Mushroom needs about 8 hours to print with 0,2mm layer height and to fit the CR2025 Batteries. It can be fully scaled to any battery-cell size needed.

Additionally you will need 

  • some colourful LEDs
  • 1 to 4 CR2025 Battery cells (depending on the Power needed)
  • and if you like a switch

For assembling wire the LEDs together and place the in the Mushroom hat (maybe use some hot glue). Strip the ends of both wires, about 2 - 3 cm. Push both wires through the Mushroom stem and the first plate. Form a spiral out of the first wire and use some superglue to fix it onto the plate. repeat with the second plate and wire.

Now you can screw the Mushroom together. Place the first plate into the Stem (wires facing down). Then put in the Batteries and sandwich it together with the second plate (wires facing up). The wires should be connected to the Batteries and everything should fit into the Stem. Screw in the Tensioner with a coin or Screwdriver and the LEDs should light up.

When you want to use a Switch you can use the Modifier function in Prusa Slicer to cut out a hole.

I made the thread following a tutorial by Originalwerks on YouTube and I got inspired by the Modell from MV3DNerd who made Spooky.

The full sized model will follow this evening.

Tagi