Spool Mount (DDD Wall Control)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount for holding filament spools against the wall control pegboard using designs from the DDD System
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 88
- Wydruki
- 0
- Wyświetlenia
- 515
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
I crated these models as a low profile way to mount a filament spool to my WallControl pegboard. It keeps the filament feed close to the wall, allowing me to feed it behind a desk into my printers.
I've been printing them out of PLA with no issue from the weight of a 1kg spool.
The arm can accommodate up to a 77mm wide spool.
I made the 3 tooth version first thinking it would be required for the weight, but I've switched to the 2 tooth version and I've had no issues. It's been a couple months.
Print Instructions / Tips
- I've been printing these with a 0.6mm nozzle at 0.2mm layer heights.
- I typically use 4 perimeters, 4 top/bottom layers, and ~40% adaptive cubic infill
- After printing, I've had to file or trim down the first layer area of the teeth (my Z has too much smoosh)