1 / 23
Futaba Monitor Mount V2 — zdjęcie 1
1 / 23

Futaba Monitor Mount V2

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I was really disappointed with the Futaba T8J Monitor mounts I have found so far, so I decided to design my own.

Ocena
0 / 5
Polubienia
4
Pobrania
43
Wydruki
0
Wyświetlenia
388
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

I was really disappointed with the Futaba T8J Monitor mounts I have found so far, so I decided to design my own. I have designed this primarily for use with the Flysight Black Pearl monitor but I will be modifying this design in the future to make it more flexible. You can use the version without the back support if you want. Although I have titled this V2 this is probably the 9th iteration I have made to get to this design.

Notes

  • It has been designed to be printed in two parts that glue together with CA or Superglue.
  • Once printed and glued the mount can be attached to the controller with 2 tie wraps.
    The back rest should be printed face down and 100% infill with support on the bed
    The base should be printed with 15% infill and no supports

    I have printed this in the new Prusa Prusament PLA filament and this looks really nice and complements the look of the Futaba T8J.

Print instructions

Category: R/C Vehicles Summary

I was really disappointed with the Futaba T8J Monitor mounts I have found so far, so I decided to design my own. I have designed this primarily for use with the Flysight Black Pearl monitor but I will be modifying this design in the future to make it more flexible. You can use the version without the back support if you want. Although I have titled this V2 this is probably the 9th iteration I have made to get to this design.

Notes

  • It has been designed to be printed in two parts that glue together with CA or Superglue.
  • Once printed and glued the mount can be attached to the controller with 2 tie wraps.
    The back rest should be printed face down and 100% infill with support on the bed
    The base should be printed with 15% infill and no supports

    I have printed this in the new Prusa Prusament PLA filament and this looks really nice and complements the look of the Futaba T8J.

    How I Designed This

Checking the fit

Filleting edges in Fusion360

Tagi