LTT Screwdriver Holder (Belt and wall mount)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a quick model I made to allow the wearing of an LTT screwdriver on either your belt or mounted to a wall.
- Ocena
- 4,25 / 5
- Polubienia
- 31
- Pobrania
- 153
- Wydruki
- 5
- Wyświetlenia
- 1213
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model uses a friction-retaining system designed for the Linus Tech Tips ratcheting screwdriver (no affiliation with LMG/LTT/etc). The retaining arms should be strong enough for daily use and they even hold the screw driver when the holder is inverted.
To positively hold the driver means that there will be some rubbing of the driver against the retaining clips. A hard material will wear your screw driver more so keep this in mind when choosing the type of material you will use to print.
Printer used: Ender 3
Print material: PLA
Supports: None for the belt clip variant, build plate only supports for the wall mount model.
Infill: I used 30%, but I wouldn't recommend less than 20% because of the rigidity needed for the retaining arms.
Print Orientation: This model was designed to be printed “upright” on the flat bottom surface of the model.