MAK Sidewinder X1 Filament Wheel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament guide and run-out sensor base for Artillery Sidewinder X1 (to remove spool holder from the top frame)
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 144
- Wydruki
- 1
- Wyświetlenia
- 1037
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you want to move the spool from the top of your Sidewinder X1 to its side, this mod is for you.
Assembly
Print all three files. Use M5 x 45/50 mm bolt as an axle for the wheel (use the printed distance ring as well).
Attach whole assembly to the frame as shown on the pictures, using screws from the factory spool holder (same goes for the run-out sensor, use the factory screw).
The 4 mm hole at the back of the base is to guide the filament to the wheel. It is angled so filament can go smoothly on the wheel. You may want to install a piece of PTFE tube in the hole (optional).
Printing
Printing is straight forward, but supports are required for base component (see pictures). The wheel and ring should be printed with no supports, the wheel preferably with 0.12-0.16 layer height.