3d printed accesories for platypus quickdraw
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have designed a set of 3d printed accessories for a platypus quickdraw filter.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 75
- Wydruki
- 1
- Wyświetlenia
- 890
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have designed a set of 3d printed accessories for a platypus quickdraw filter. They include a two piece attachment which allows for a small circle of cloth or filter paper to act as a pre filter, an attachment for a lifestraw activated carbon filter and barbed attachments for both the dirty and clean sides of the platypus, which allows for the filter to be converted for use in a gravity filter system.
The design of the quickdraw with O rings and gaskets on every outlet make this relatively simple and leak free. The major concern is the porosity of 3d prints and their potential to hang on to bacteria. This could be dealt with in a few ways. I've tried coating a few parts in a food safe epoxy, which is the best solution and works pretty well but is a little tedious. Alternatively, I expect you could just keep the dirty/clean ends separately and not worry about it throughout the trip and bleach them in between trips.
The barbed connections need to be printed with support, but all others have been designed to print without supports. This is very much a work in progress, and the files will be getting updated and added to as I refine things.
Should be printed in petg for food safety and strength