Skadis TNut Hooks with offsets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3 hooks with their mounting points offset by 5mm. Uses the 2.5mm TNut mounting system on Skadis pegboard.
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 92
- Wydruki
- 1
- Wyświetlenia
- 612
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
There are 3 hooks for use in a Skadis pegboard. Each has its mounting point offset by 5mm to allow two hooks to be used to support 2 uneven ends of a single tool. See the picture of the hammer for an example. This is designed to support the 2.5 TNut connector. To use the M3 mount system simply drill out the inner hole using a 3mm drill.
Any material
6 or so perimeters so you get 100% infill
0.2 layer
paint on some support for the alignment nubs
a 3mf file (from MK3+) is provided which sets support for the 3 different hooks