Honda CBR 600 F4i Sport 2002 replacement seat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Honda CBR 600 F4i Sport 2002 replacement seat
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 1214
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Replacement seat for Honda CBR 600 F4i Sport 2002
My original seat is away to be reupholstered with gel inlay, to obtain a more comfortable ride.
Unfortunately the bike unexpectedly had to go to the shop for some repair work, and I need to ride it home from there when it's done. Wouldn't be a fun hour-long ride without a seat!
So I did some measurements and fired up Fusion 360, and managed to do a test-fit of the brackets and seat plate before the bike was picked up - then mounted the foam and leather on the seat afterwards.
In the brackets where the bolt attaches everything to the bike, there is an indentation for a 16mm washer - I glued my washers on with super glue, since dropping a washer down between all the wires etc. is an easy mistake when mounting it otherwise.
I used regular mounting screws from Biltema to fasten everything to the seat.
I really recommend doing a test-fit before upholstery, since it will give you a chance to draw outlines on the bottom of the seat plate. This will make it much easier to re-mount everything once the upholstery is done and partially covering the bracket positions.
The leather and foam I used here is from an Ikea sofa seat I found at the local thrift store for about $3 - score!
The picture showing a wooden beam across the seat while upholstering, is because I used that to compress the foam while stapling the leather on as much as I could before releasing - that way I got a tight fit without problems.
Also, sorry to all the real upholsterers out there, I'm sure my “work” here is an ugly mess - but hey, for my purpose it will do ;-)
I don't have a drawing of the seat plate itself, since I just cut out a prototype from cardboard, then traced it to wood and sanded it to fit, no real measurements etc. involved.
But to give you a chance of actually making a drawing to work from, I ran the seat plate through my laser and engraved a grid for reference - the grid is 1 * 1 cm squares.
The center bracket is pretty much just there to help align the seat when mounting it, it doesn't carry any weight, it's all transferred to the rear mounts and from there to the frame of the bike.
I expected needing to re-print several times before getting a useable result, but this first version worked fine so I'm keeping it - it's PLA, but I only need it for about one hour, so it will be fine.
I recommend printing in ABS, PETG or other higher-temperature materials, especially since ABS and PETG tends to stretch/deform rather than snap/break like PLA.
Video of the result: