skilsaw straight edge wall-ceiling hanger-with locknut
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
modified straight edge holder
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 285
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I liked the original but I had a couple changes I needed to make. Size was not what I needed. Not the big issue I had, an issue with the rotating hold back part. Since it was just screwed into (threads were very good) the plastic- not only were you not able to tighten well but the screw worked loose with use. I opted out to changing the base to suit the size I required and instead of threads in plastic used an embedded locknut. Changed the hole for the original bevelled screw to accommodate a socket head machine screw. That took care of both issues. There is a pause code in the file for time to insert the locknut (note the direction flat part toward the top). As well a colour change for the arrows. Yes this way does require support (included in file when sliced).(paint on snug supports)
Colour change for directional arrows on top rotating sectional part in file
PLA or PETG (preferred)
.4 nozzle
.2 or .3 resolution
support (built in)
for each holder section
M3 bolt 16 -25 mm
M3 locknut