Heart shaped zipper pull
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Zipper pulls that work with 2mm "paracord" or 1.75mm TPU .
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 131
- Wydruki
- 2
- Wyświetlenia
- 631
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed as valentines favours, these zipper pulls can be attached to jackets, backpacks, pencil cases, or anything with a zipper.
*Printed without supports
Assembly instructions:
Cut about 6-8.5 inches (15-20cm) of 2mm nylon paracord/1.75mm TPU then thread each end through the small openings at the top of the heart. Tying a piece of dental floss to an end of the cord can help with this, or use tweezers to push cord into the holes and then pull them through the other side when you can see it on the other side. tie a knot once both ends are through and secure the knot in the large opening at the bottom of the heart.
Attaching to Zipper:
feed paracord/TPU loop through zipper pull tab opening, feed heart through loop and pull (see image for what it should look like).
Tips:
If using TPU, to keep the knot from undoing itself, you can heat and fuse the knot.
if using paracord, before feeding through heart, burn the ends to prevent them from unwinding.