OmniBox short lower bay tray for Wago
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
OmniBox short lower bay tray for 3x Wagos where they stand on edge in a holder
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 17
- Wydruki
- 0
- Wyświetlenia
- 197
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a short lower bay tray for the OmniBox to hold three Wago 221 series units vertically. It will hold the 221-415 as-is, or the 412 and 413 units with a little insert to keep them from moving around (put the insert in the slot first). My use case was to place the mains in a corner at the back of the lower tray and this is working well for me. Initial wiring can be a challenge depending on your layout, but the Wagos slide in/out very easily. Use two M3x5 or M3x6 screws to hold the strap in place.
Choice of material shouldn't matter so PLA or PETG should be fine if the OmniBox will be on a desk and has good ventilation. If it is where it gets hot or has poor ventilation, then ABS/ASA are recommended.
Designed to be printed with a 0.2mm layer height using a 0.4mm nozzle. Tolerances are a bit loose but could be an issue if your printer needs fine-tuning. Use standard print settings for the tray and cap/strap. The inserts can use reduced walls/infill to save on material as they are not structural and bear no meaningful weight from the Wagos sitting on top of them.
For more information about the OmniBox, please visit https://www.printables.com/model/354643-omnibox or https://jon-harper.github.io/OmniBox/ (main docs for the project).