Tesla Model 3 Trunk Hook Extended - Supportless
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Elongated Remix of threaded trunk hook for the Tesla Model 3.
- Ocena
- 5 / 5
- Polubienia
- 76
- Pobrania
- 387
- Wydruki
- 5
- Wyświetlenia
- 3440
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Extended another design for a trunk hook by 2cm at the stem to better accommodate access to the hooks.
The bottom of the hooks have slightly problematic overhangs, so I enabled supports from build plate. --v3 Should not required supports
I also printed this using adaptive layer heights to improve layer adhesion on some of the object interface points, while also maintaining a reasonable print time.
I'd recommend PETG or better for anything that has to endure the heat that can build up in a car trunk, however I originally printed it with PLA+ (Inland) and used it throughout the summer without issue.
Changelog:
July 30, 2025
Uploaded a version 3 that is printable without supports, based on another design that's credited in the remix section. A much better way to handle steep overhangs compared to my v2, which I will now delete.
Jan 31, 2021
Uploaded a version 2 that has a maximum overhang of 60 degrees
Print instructions
Print Settings
Printer Brand: Prusa
Printer: I3 MK3S
Rafts: Doesn't Matter
Supports: Yes*
Resolution: 0.15 (Adaptive)
Infill: 40%
Notes:
Minimum 3 perimeters. Gyroid Infill.
* v3 does not require supports.