Simple GT2 Belt Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This clip is sized for GT2x6mm belt.
- Ocena
- 5 / 5
- Polubienia
- 13
- Pobrania
- 161
- Wydruki
- 2
- Wyświetlenia
- 975
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
This clip is sized for GT2x6mm belt. I was getting tired of putting wire ties on assemblies that kept changing as my design changed. I looked for some simple clamps, but couldn't find something that appealed to me. I initially was not concerned whether it held up for long, but just long enough to see whether the current iteration worked. I was pleasantly surprised how well this simple clip worked. These have been on for over a week & still holding up well.
I printed these in PLA+ to give them a little bit a give in them & put 2 on each side of the carriage.
I also included the fusion 360 file if you want to change for wider belt.
Category: 3D Printer Accessories