Hela Figure

Hela Figure for display.

Idk what you would normally call it but edited 2 models into one and tied it to repair the models where there are no holes and should print without any issues.

I am new at this and trying things out.

The 2 models I used were from

(Hela Miniature)(base and crown): https://www.thingiverse.com/thing:4173111

(Hela - MUA3) (body): https://skfb.ly/6Zy8S

You should be able to split the model up in Meshmixer to print them one by one.

I mean, print it as you would normally print your action figures.

I use too many different settings for different parts I don't even remember.

You can try to print the thing in one piece (Not recommended).

Try to cut Parts up as you feel comfortable.

I had to make holes with my small screw diver in the body and arm .2mm +screw driver

by heating it up with a candle and making a hold in the arm and putting the filament sting in it and trying to join them that way.

This Project was a Gift to a close friend.

Will upload the Picture when I am done sticking the parts.

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

.16

Infill:

Filament: any PLA and PLA+ White

Notes:

Category: Sculptures