Gridfinity Push together Baseplate - Magnet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My take on a Gridfinity baseplate that uses "raw" filament as pins to friction fit baseplates together. Magnet Version
- Ocena
- 4,875 / 5
- Polubienia
- 196
- Pobrania
- 862
- Wydruki
- 9
- Wyświetlenia
- 5217
- Oceny
- 8
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
Introducing what I believe to be the perfect Gridfinity baseplates with a good balance between functionality while lowering material use.
I wanted baseplates that could be used standalone or fit together to create one bigger baseplate e.g. for covering a bottom of a large drawer without using any additional hardware while making sure they stay aligned.
These baseplates have holes around the edge to friction fit multiple baseplates together using a “pin” made from “raw” filament. The filament should be a tight enough fit to hold multiple baseplates together although if you are finding the holes a little too small the best thing to do is chuck a short piece of filament in a drill and use the filament as a drill bit to ever so slightly enlarge the holes to a perfect fit.
If you want more of a permanent fit you can either flatten the ends of the pin with a pair of pliers or you can melt the ends with a lighter and use the hot metal on the lighter to flatten the ends.
This is the Magnet version in which you can press fit a 6x2mm magnet although these are compatible and the same outer dimensions with my lite version that can be found HERE.
All sizes from 1x1 to 10x10 have been included.